Factors to Consider When Choosing the Best HVAC Services Tampa
Ac installation involves a series of steps that is divided into three parts. The first is installation of the indoor unit which involves a considerable amount of steps like; selection of an unobstructed location on the interior wall to mount the indoor air conditioning unit, securing of the mounting plate to the interior wall and creation of hole to fit in the piping among others. There are some dos and don’ts that need to be observed during selection of an unobstructed location on the interior wall to mount the indoor air conditioning unit.
Some of them are avoiding direct sunlight and heat sources, installing the unit at least one meter away from the antenna, connecting lines, power, radio, television, telephones etcetera, the wall should be strong enough to hold the weight of the unit and avoiding locations where oil mist exists or gas may leak.
In order to secure the mounting plate to the interior wall then some steps are followed. Holding the mounting plate against the wall, using a level to make sure the plate is horizontally level, drilling holes into the wall at appropriate spots to affix the plate to the wall and finally inserting plastic anchors into the holes are the steps of securing the mounting plate to the interior wall. So as to fit the piping then a hole is created. Some directions have accompanied the steps of creating of a hole in the wall to fit the piping.
Lifting the unit’s front panel, removing the cover and being sure the cable wires are connected to the screw terminals is under the process of checking the electrical connection. Connecting of the pipes follows suit coupled with other procedures. Connection of pipes involves a lengthy procedure in which finally the drainage pipe allows water to drain in an appropriate place.
The final step to the first part of AC installation which is installation of the indoor unit is securing the indoor unit to the mounting plate by pressing the unit against the mounting plate. Installation of the outdoor condenser is the second step in AC installation. Choosing the best place to the outdoor unit which also involves choosing the outdoor unit location needs away from any hot, trafficked areas and having a considerable space that ensures proper functioning is involved in installation of an outdoor unit. The next sub step is laying and leveling the ground using a concrete pad. The concrete pad should be high enough so that the condenser sits above winter levels.